Cody J.
NHD StaffApplications Engineer at Newhaven Display.
- Following 0 users
- Followed by 1 user
- Votes 1
- Subscriptions 23
Comments
Recent activity by Cody J.-
Hello Leandro, Can you confirm that the system is supplying 5V to the display's VDD line and is using 5V control signals? Best Regards, Cody J
-
This question is currently being answered via email.
-
Hello Leandro, Thank you for the information. Without access to source code, I'm not sure if there is much I can do to help. It may help to test each LCD type setting, however I am not familiar wit...
-
Hello Leandro, Thank you for your interest in Newhaven Displays! I have a few questions about your issue: Have you referenced the example code for this display? What are you trying to draw/write o...
-
FYI, the contents of tester_init.h has been added to the Serial Interface C Code page. Thus, the comment I created has been deleted to remove duplicate information.
-
Hello Leo, The base slave address for NHD-0216CW is: 0x3C if SA0 is LOW 0x3D if SA0 is HIGH This information comes from section 5.1.4 MCU I2C Interface in the display's US2066 controller IC spec ...
-
Hello Leo, The contents of tester_init.h has been posted in a comment on the Serial Interface C Code page. Please take a look and let me know if you have any questions. Cody J
-
Hello Fetman, Can you provide the full display part number? Can you provide a photo of the back of the display? Can you provide a photo of the issue you are experiencing? Do you have other NHD-C12...
-
Hello Artz,To answer your questions about the NHD-0216SZ-NSW-BBW: The on-board resistor for the LED (R8) is 680 Ohms. The voltage drop across the LEDs is 5V. If you have any questions, don't hesita...
-
Leandro, Thank you for the information. Do you have access to the code used to initialize and drive the LCD? If so, it would be useful to see the initialization and character/graphic write function...