Cody J.
NHD StaffApplications Engineer at Newhaven Display.
- Following 0 users
- Followed by 1 user
- Votes 1
- Subscriptions 23
Comments
Recent activity by Cody J.-
Hello Tomas, Our capacitive touch panel sensitivity is configured during manufacturing. Manual touch sensitivity control is not possible. If sensitivity modification is required for an application,...
-
Hello Keegan, Thank you for your interest in Newhaven Displays! We do not have PWM brightness control example code for Raspberry PI 4. To learn about RPi4 and PWM, I recommend starting here. The fr...
-
Hello Brandon, Thank you for your interest in Newhaven Displays! The US2066 does not have any stated maximum execution time for the commands within its command set. The best we can recommend is, if...
-
Hello CuriousEngineer, Thank you for your interest in Newhaven Display! Can you provide more information on the software used to drive the display? Are you using a library or your own code to drive...
-
This issue is being supported via email.
-
Hello Wmotter, I recommend using the initialization sequence seen in the Arduino code and make sure it matches the initialization code seen in the associated spec sheet of the exact display you are...
-
Hello Wmotter, We will investigate the non-Arduino example code you mentioned. The Arduino code you are referencing does work with SPI, it bit-bangs the SPI protocol. When global variable mode is ...
-
Hello Wmotter, You can find the contents of reg52.h near the bottom of the example code article. This article was just updated a few minutes ago. This file defines the registers for the associated ...
-
Hello Randy, Yes, NHD-4.3CTP-SHIELD does have PWM backlight control via the FT801 IC. Using the FTDI_FT801 Arduino library, write to the REG_PWM_DUTY register to adjust the display's backlight. Kee...
-
This issue is being supported via email.