Saurabh_B
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 241
Comments
Recent activity by Saurabh_B-
Hello,The VLCD is generated by the booster circuit on the display and is controlled via software (Set Electronic Volume Command). This voltage doesn't need to be applied, and you should see 9~11 V ...
-
Hello Charlie,Sorry for the delay, The heater should be activated whenever the display starts to show any signs of lag from the cold weather.This will typically start to occur ~-10°C. However many ...
-
The flickering can be caused by a lack of current being supplied to the voltage boosting circuit. Would it be possible to record a video of the flickering that occurs?
-
Hi, Do you have a limit as to how much current your VDD line could supply?
-
Hello,I have used this display and the pinouts do confuse a few people. However i can confirm that when you are looking at the front of the display the pin on the far right is the Reset pin. The sc...
-
Hi, The initialization process that occurs after reset does leave the display OFF. You would need to turn it on.I would also recommend repeating the initialization that occurs after the reset if yo...
-
Mike, That could be a possibility, however, you could always delay writing to the display until the voltage reaches 5 V
-
Mike,Your jumper settings seem fine.Would you possibly be able to share your commands for how you send bits to the display? Are you also pulling the STB pin low for the 2 Bytes you send to the disp...
-
Hello,Our displays / CTP panels come with the FT5X06 controller.Doing a quick search I wasn't able to find the register values for this controller.I would recommend contacting the company you bough...
-
All of our character LCDs can use one of the font tables that are found here: https://support.newhavendisplay.com/hc/en-us/sections/4415148857751-LCD-Character The controllers used for these LCD's ...