Saurabh_B
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 241
Comments
Recent activity by Saurabh_B-
I think you're looking at the pictures and taking those positions as pin outs. you want to use the pin out numbers listed on page 4. On page 5 the pins are backwards, so pin 1 and 2 on the sketch...
-
Mark,You should not need to use a negative voltage input.You would tie one end of the Temp comp circuit to the +3.3V, and the other end to 0V.The V0 will be the same pin as VL.
-
HI,This display does have a temperature compensation circuit built in.This circuit is tied to both the VDD, so modifying the input voltage will affect the contrast. The VLCD is VDD-V0, the V0 is su...
-
Felix,Yes there is a minimum execution time for commands sent to the display. You can find the minimum execution on the table in page 6 of the display specification.Display Specification
-
Hi Felix,Do you have anything tied to the RS pin on the display? (I did not see this in your picture)If so, have you initialized the display?
-
I was wondering if you would be able to confirm that both R1 and R2 are open on the back of the display. Also for this display the RS232 communications are supposed to be at TTL Logic levels, can y...
-
Hi would it be possible to post a picture of the black boxes.Could you also check the voltage on pin 3 of the display?
-
Hello Kent,I will need to power this display up to see if I can replicate the spikes being caused by this display.Unfortunately the Logic LOW for the ACK is caused by the controller.We will have ...
-
Hi,It will take 100 µs (Max) to execute a write instruction. This means that you will have to wait 100µs between character writes. The 5µs is the wait to generate the longer clock pulse.
-
Hi,The NHD-0216HZ-FL-YBW-C has a 0.1" or 2.54mm pitch thru-hole connection.Did you mean the NHD-02161Z-FSY-YBW-C?This display has a 16-POS, 1mm Pitch FFC cable connector, its recommended connector ...