Sergio_M
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 35
Comments
Recent activity by Sergio_M-
Hello Jon,Have you tried what is suggested in this ODROID Wiki post?https://wiki.odroid.com/odroid-xu4/application_note/software/hdmi_custom_edidHere are the RGB timings we use for the EVE2 that ma...
-
Hello Jon,Thank you for your interest in Newhaven Display!Please view the attached EDID Timing table, it should have what you are looking for in regard to the start and end positions for the Sync ...
-
Hello,A good place to start is looking at our NHD-FT81x-SHIELD user guide: https://newhavendisplay.com/content/userguide/NHD-FT81x-SHIELD_User_Guide.pdfTFT module data sheet: https://newhavend...
-
Hello,Unfortunately, the Due is not compatible, the NHD-FT81x-SHIELD requires an operating voltage of 5V to be supplied by the Arduino.The Due's IO pins are not tolerant of the 5V levels from the s...
-
Hello,You may use the resistive touch panel by either using an external 4-wire resistive touch controller IC such as ones offered by Microchip, TI, etc., or by using your MCU's ADC pins and manuall...
-
Hello,The recommended FFC connector is Molex 54104-4031 or equivalent.Hope this is helpful.
-
Hello,I'm sorry to hear you are having issues with the module.Can you please confirm you are using a known compatible Arduino (UNO, NerO, Leonardo, Mega 2560) and at least a 5V DC power supply with...
-
Hello,The ghosting or image persistence is typically not permanent on TFTs. The effect can be corrected by exercising the pixels over time.Some users will scroll or shift the image on the display r...
-
Hello,Sorry to hear the display stopped working, was the conformal coating applied to the entire display?When using conformal coating we typically coat a chip-on-board display applying conformal co...
-
Pin 3 of the display is tied to the bias voltage circuit which you can see on page 29 of the controller datasheet. The 0.6V for optimal contrast specified in the display datasheet is what you shoul...