Engineering Support
Community moderator- Following 0 users
- Followed by 1 user
- Votes 10
- Subscriptions 784
Comments
Recent activity by Engineering Support-
Hi Artur, The NHD-3.5-320240JF-ASXP-CTP display does allow you to adjust certain parameters over SPI such as timing parameters and display mode setting. However, in most cases, it is not necessary...
-
Hi Hiroki, Unfortunately, I cannot think of a reliable method that would detect which display version is connected, unless the I2C read function is implemented. One hardware-level difference I’m aw...
-
Hi Hiroki, Unfortunately, we do not currently have the resources to develop and verify new example code for I2C Read Data functionality with the ST75160. We understand that the ST75160 datasheet ca...
-
Hi Rex, Sorry for the inconvenience. The Newhaven Display website was briefly down due to a technical issue but is back online now.
-
This query has been addressed through email communication
-
This has been answered through email
-
Thank you for the queries that you sent. The NHD-4.3-480272FT-CSXP-CTP display is the direct replacement to the EOL display with only the following differences. The typical drive current for the L...
-
Hi Hiroki, To my knowledge, the ST7528 IC does not support read operations over I2C. The read functionality is only supported by the SPI and parallel interfaces, which are not brought out to the F...
-
Hi Adam, Thank you for sharing the issue and for providing the working solution. It is likely that the original library was written specifically for 8-bit mode. The issue may also be related to t...
-
Hello, It is not possible to configure the NHD-2.4-240320AF-CSXP display for 4 wire SPI as the IM3 pin is internally ties to 1 and the IM1 pin is tied to 0. The best alternative that we provide whi...