Engineering Support
Community moderator- Following 0 users
- Followed by 1 user
- Votes 10
- Subscriptions 781
Comments
Recent activity by Engineering Support-
Hello Kyle, Thank you for the added information. I took a look at your schematic again and noticed you have series resistors connected to the parallel data lines to the display. Can you remove the ...
-
Hi Kyle, Thank you for sending the schematic and code. I've reviewed the schematic and it seems the voltage for the contrast is too low. I see you are using a voltage divider with 10K Ohm and 100 O...
-
Hi Kyle, Could you please provide your schematic or wiring diagram for your setup? While both the displays have the same IC, the initialization is different. Your initialization commands seem right...
-
Hi Manoj, The circuit looks good to me. Regarding the reliability of the connection, I can't really say because I don't have the PCB design as a reference. If you are using proper interconnects for...
-
Hi Manoj, I would suggest either using an optocoupler IC or a digital isolator IC. Both should work in this case. More over, I would also suggest taking a look at the ISO154x from TI. They made an ...
-
Could you please provide your wiring diagram for the display? I also wanted to ask is your LTDC configuration setup for 24-bit RGB interface?
-
Hi Furkan, Thank you for the date codes. I wanted to ask what your RGB mode is? You need to correctly set the RGB interface mode to utilize the relevant pins. Some pins need to be connected to GND...
-
Thank you for testing the different settings. Could I get a picture of the back of the display? This is so I can see the date code.
-
Could you also try to change the Data Enable Polarity to active high?
-
Hi Furkan, Can you try setting the Data Enable Polarity as active high and see if that fixes the issue? Could I also get a picture of the back of the old screen that worked so I can check the dat...