Cody J.
NHD StaffApplications Engineer at Newhaven Display.
- Following 0 users
- Followed by 1 user
- Votes 1
- Subscriptions 23
Activity overview
Latest activity by Cody J.-
Cody J. commented,
Hello Ihab, We have some some Arduino example code on our GitHub page: NHD-2.4-240320CF-Cxxx_Example. Some older example code is available on our website as well: 2.4" TFT - ST7789 Controller Best ...
-
Cody J. commented,
Hello Ihab, NHD-2.4-240320CF-CSXN#-F only uses parallel interface. When pushing the parallel interface to its limit (pixel clock cycle of 66ns), you can theoretically achieve approximately 197fps. ...
-
Cody J. commented,
Hello Daniel, It is great to hear everything is working! If you have any questions or issues during development, don't hesitate to reach out again. Best Regards, Cody J.
-
Cody J. commented,
Daniel, Thank you for providing the photo. You mentioned adding external power to the 5V and GND pins on the Arduino. Can you try adding external power to the VIN and GND pins? (Circled in red in t...
-
Cody J. commented,
Hello Daniel, Thank you for your interest in Newhaven Displays! Can you provide one or multiple photos of your overall setup? (Arduino Uno + NHD-FT81x-SHIELD + NHD-5.0-800480FT-CTXL-CTP) It is poss...
-
Cody J. commented,
Hello Guy, My best guess, since it is difficult to access the firmware, is that the diagnostics page is using byte codes that may be invisible on the old display, but are visible on the new display...
-
Cody J. commented,
Hello CuriousEngineer, Thank you for the detailed explanation. I recommend taking a look at this example program, specifically at the function at line 115. This function implementation may be a goo...
-
Cody J. commented,
Hello Guy, It is possible there is an interface timing issue occurring. However, it is tough to dig deeper into the problem without knowing more details about the software driving the display. Are ...
-
Cody J. commented,
Thank you for the information.Try adjusting the contrast via the "Power/ICON control/Contrast set" and "Contrast set" commands first.Contrast is a 6-bit value.The following command sequence will ...
-
Cody J. commented,
Hello GarryBarton,What capacitors are you using in your current display circuit between C1+/C1- and on VOUT?Best Regards,Cody_J