Saurabh_B
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 241
Comments
Recent activity by Saurabh_B-
This does sound like something is causing the display to reset externally.You should be able to fill the frame buffer at any time. After the display re-initializes and you send the display ON comma...
-
Do you know if the voltage applied to the display pins 7&8 is constant the whole time.Another cause could be a reset caused by either a loose connection or just power dropping.Finally do you know i...
-
Hello,It sounds like the display is getting reset.Do you know if the Reset Pin on your display is tied high constantly?
-
What is the current limit for your backlight supply?For the backlight you would not need to apply the Display Enable signal. Also could you give me a date code for the display you are currently using?
-
Hello,You will be able to bend the cable at that point. The cable there does have a bend radius of about 1.5mm, and you would be able to bend that up to 180°.We often mount the controller board dir...
-
Hi,Either the 54104-4031 or the 54132-4062 will work just fine, The deciding factor is where you would be likely to mount the display. On our controller they use a top contact FFC connector because...
-
Hi peter,Two options you have to connect the -34 controller board to your arduino.1. You can use the NHD-FFC36 with a 34 Pos 0.5 mm Pitch FFC such as THISBecause the PCB has a 36 position Molex con...
-
Hi Jack,By default the display is already in DE mode, to put the display into Sync mode, you would need to short the R4 jumper on the FPC below the display.
-
Hello Bill,Unfortunately because these are Passive Matrix OLEDs the brightness of the pixels can vary based on how many pixels are on in a row.The brightness will be higher if you only have a few p...
-
HI,You would need to connect the display to the controller board, then from there the controller board would need to be tied to your processor.The connections would depend on the ports and pins on ...