Saurabh_B
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 241
Comments
Recent activity by Saurabh_B-
Would it be possible to get a picture of your display and the code you are using?I would like to see if we can recreate the same problem.
-
Hello Joel,1. Yes the display will work at 100khz2. The supply current is dependent on what the display is showing and how far you are using the voltage booster, it can use up to 1 mA of current wh...
-
Can you tell me if what the voltage on pin 6 (VOUT) is?If the voltage booster circuit does not activate it could mean that your instructions are not being read by the display. Do you by any chance ...
-
Hello,It looks like you have the display wired backwards. Pin 1 of the display is on the right side of the display. Please see picture below: I would also recommend the use of a level shifter (5V t...
-
Are you sending a delay between the commands or allowing the commands that were sent to execute?
-
Thank you for sharing!
-
Unfortunately we do not have a guide on how to do this with linux.However there are plenty of libraries and tools available that can help you drive the display.I would recommend looking at the foll...
-
Can you give me more information about where the display is used?I can see what you mean by the browning on the display, this leads me to believe that something is causing extreme heat build up on ...
-
Would it be possible to send a picture of what you are seeing.Also what temperature is the display used in, and what is the voltage on the display?
-
Yes, you would be able to solder a 2x8 pin header onto the display.You will need 2.54mm pitch, or 0.100" pitch pins for this.