erps

  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 2

Activity overview

Latest activity by erps

  • erps created a post,

    16-bit controller Board (SSD1963) for 5.7inch QVGA TFT display

    1. Community
    2. Evaluation & Development Tools

    I need a Digital controller board for 5.7in TFT displays. 3.3V input. 16-bit parallel MCU interface.Controller/Driver: SSD1963-16bitI guess the part number would be NHD-5.7-320240WFB-34 Controller ...

    • erps
    • 1 follower
    • 1 comment
    • 0 votes

  • erps commented,

    1. Community
    2. TFTs
    3. Vertical colored lines

    Nothing in particular with the initialization code itself but where this code was place. I am using some ST code examples using the STemWin library and I was placing the initialization code in the ...

  • erps commented,

    1. Community
    2. TFTs
    3. Vertical colored lines

    It was an initialization issue. Once the correct initialization code was set on place the display start working.

  • erps commented,

    1. Community
    2. TFTs
    3. Vertical colored lines

    Thanks, it works now but still an issue during power on. Sometimes the display doesn't come up after a power cycle. I have to try several times either power cycling it or reset the board, for the d...

  • erps created a post,

    Vertical colored lines

    1. Community
    2. TFTs

    Hi:As a general question, what would be the reason to get vertical colored lines on a display? (see attached)I am using NHD-5.7-320240WFB-ETXI #-T-1 with SSD1963 controller board.Display is connect...

    • erps
    • 3 followers
    • 7 comments
    • 0 votes

  • erps created a post,

    NHD-5.7-320240WFB-ETXI #-T-1

    1. Community
    2. TFTs

    Hi:Need code example to drive the TFT display NHD-5.7-320240WFB-ETXI #-T-1 using the SSD1963 controller board.I am using a STM32F2 microcontroller using FSMC 16-bit interface.Can you help?Thanks,

    • erps
    • 1 follower
    • 1 comment
    • 0 votes

  • erps commented,

    1. Community
    2. TFTs
    3. NHD-5.7-320240WFB-ETXI #-T-1-ND

    I am going to use the interface board NHD-FFC36-ND.Can you provide dimensions on that board?Distance between Mounting Holes?Thanks,

  • erps created a post,

    NHD-5.7-320240WFB-ETXI #-T-1-ND

    1. Community
    2. TFTs

    Hi:I need a 32-position flat flex ribbon cable to connection the signals from the display to the uC board.Do you provide for that?Another question, the datasheet on page 4 shows connector CON2 as t...

    • erps
    • 2 followers
    • 3 comments
    • 0 votes