Ted M.
NHD StaffApplications Engineer at Newhaven Display
- Following 0 users
- Followed by 1 user
- Votes 0
- Subscriptions 212
Comments
Recent activity by Ted M.-
Hi Chethan,The attachment is not readable. Please try again Regards,
-
Hi Chethan,It is possible this could be an issue with either the electrical interface or the software and initialization code for the display.Please provide the wiring diagram for your configuratio...
-
Hi Vkellogg,The software compatibility for the US2066 using code written for the HD44780 controller will vary on a case by case basis. There is no way to predict if any given code will work on the...
-
Hi FrankT,Unfortunately the NHD-1.69-160128G display with the SEPS525 controller does not support Serial Data Out. Currently our datasheet indicates that SDO is tied to DB[15] as it also shows in t...
-
Hi Martin,For 3.3V operation, use the 2.8V low voltage setting. The low voltage I/O setting will work for logic levels from 2.4V up to 3.6VThe jumper SJ1 will connect the 5V VDDIO to REGVDD which ...
-
Hi m_ozzie,Please see the github code from the following link that shows the Command() and Data() function definitions.https://github.com/NewhavenDisplay/NHD_US2066/blob/master/NHD_US2066.cppRegards,
-
Hi Kishan,Here is some working Arduino example code on our Github site that may help you to test the display.https://github.com/NewhavenDisplay/NHD-1.1-9696GBest Regards,
-
Hi Myeongsu Han,The NHD-0220DZW-AG5 is still a current and active product that is available and can be recommended for new designs. There are no plans to discontinue it and it will continue to be ...
-
Changing the resistance to lower the Iref will affect the overall contrast level range that can be adjusted in software, however it may not produce a counteracting effect to the displays lifetime. ...
-
The datasheets Optical Characteristics table is based on setting the typical value of +9V for VCC. This voltage is mainly used to power the OLED Glass.Increasing this voltage will affect the OLED...