Engineering Support
Community moderator- Following 0 users
- Followed by 0 users
- Votes 10
- Subscriptions 777
Comments
Recent activity by Engineering Support-
Hi Will, Thank you for your inquiry. You need to solder a 1x20 pin header to interface with the display.
-
Hi Rafael, Sorry for the confusion, could you please refer to page 16 and 17 on the BT81X Series Programming Guide? The section is Initialization Sequence during Boot Up. Please let us know if it w...
-
Hi Rafael, Are you able to share the function "write_spi_pantalla"? Could you try also set your registers first and then end the display list? After this, add CLEAR_COLOR_RGB and CLEAR followed b...
-
Hi Ts, Unfortunately there isn't. If you purchase this part through one of our distributors you can initiate a a RMA through them. If you purchased through us, you can contact us at nhtech@newhaven...
-
Hi Volker, I will email you this information.
-
Hi Ts, I am glad the code is working ! As for the other unit, maybe the the firmware on the IC got corrupted. Also, if you are interested on the latest version of this display please check out NHD-...
-
Hi Volker, You would have to create code to write the timing values to the EDID EEPROM IC. With the cable suggested earlier, you should be able to connect jumper wire to your microcontroller. You c...
-
Hi Marc, Volker, and Demicropz, We have tested this part here with Win11 just to confirm that the display works properly with that OS, and confirmed that the display worked without any issue. Whil...
-
Hi Ts, You can use GND and 5V directly. For Pin 1 please go ahead and wire to 5. I updated the code in the previous comment.
-
Hi Volker, Unfortunately, we haven't received anything. We will be emailing you directly.