Data Address

rwamser

• October 21, 2016 09:07

I am using a NHD-0420E2Z-NSW-BBW and I can send Characters to the display but The problem I have is after send characters to the first line ( that works just fine ) When I try to send Characters to the second Line they all go to the Third Line regardless of what Character address I use It appears that the address that I am sending is not being used and what the Display is doing is advancing the start address by one automatically in that the display goes from Line 1 to Line 3 to Line 2 then Line 4.  So how do I get the Display out of automatic address advance and be able to place a character where ever I want 
Richard

0

• 

  Saurabh_B

  • October 24, 2016 09:07

  Hello,
  
  Are you sending a command to go to line 2? [command(0xC0);]
  
  Because of the way the controller is set-up, the RAM Address can be found on page 5 of the display datasheet.
  You would need to use the Set DDRAM Address to move to line 2.

  0

Please sign in to leave a comment.