Saurabh_B
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 241
Activity overview
Latest activity by Saurabh_B-
Saurabh_B commented,
The first thing you would have to do is to add a short delay when the power is applied.Then before you start writing I would recommend sending the return home command.There is also a clear display ...
-
Saurabh_B commented,
Hello,Unfortunately we do not have any LCD simulators.
-
Saurabh_B commented,
What changes have been made to the initialization?
-
Saurabh_B commented,
Guenther,I will look over your code for any mistakes.All displays are tested before they leave our Facility, chances that it is DOA is fairly low.You can provide 3.3V to both the VDDIO and VDD pins...
-
Saurabh_B commented,
Peter,You will not be able to see anything on the display without the backlight. For TFT displays the backlight is a requirement.The NHD-4.3-480272MF-34 controller board does have a voltage booster...
-
Saurabh_B commented,
Hi Peter,Unfortunately most LCD's are not waterproof on their own. You would need to put inside of a waterproof enclosure. It seems you are already taking care of that with the carbon fiber enclosu...
-
Saurabh_B created a post,
Korg Wavestation (A/D & EX Models) LCD Replacement
This is pretty useful for anyone who want to replace the LCD for their Korg Wavestations (A/D and EX models). The backlight on these synthesizers uses and electroluminescent panel. These often have...
-
Saurabh_B commented,
Hi,I was wondering if you could give me a little bit more information:1. What size display are you using?2. Would you be able to provide the date stamp on the touch panel of the FFC of the touch pa...
-
Saurabh_B commented,
The backlight should turn on so long as you have the cathodes grounded and the anode tied to Vdd. I would measure the voltage across the cathodes and anode.With the tight area, I would recommend al...
-
Saurabh_B commented,
Hey Jesse,I'm not seeing a connection from the backlight cathodes to ground, they seem like they're tied together but just floating.Other things I would change is having the Reset pin attached to t...