dfansler
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 4
Comments
Recent activity by dfansler-
I realize I can use the 20 pin flex cable and that the connector on the NHD controller is 22 pin - my question is what NHD connector do I need on my custom board to interface to the 20 pin cable?Th...
-
OK - I have run into another problem with the board. I am running the controller board from a custom interface board. The connector on my custom board is a 20 pin bottom contact 1mm pitch yet the...
-
Thanks for the quick reply!David
-
Very small - only 2 changes, one to go from 18 bit to 16 bit and one to raise the refresh rate.The unit will only show true colors if I delay at least 4ms between sending each data word. This is re...
-
ok - thanksDavid
-
Now that I have the display running - and it will only run using the ILI9328 code, I have started to try to fine tune the timing to the display. The values I am having to use are MUCH larger than...
-
Hi Saurabh_B - thinking you were probably off for Good Friday, so I looked at the data on the different examples of code for the 2.4 display, and tried the 3 that seemed post probable.The ILI9340 w...
-
Saurabh_B: here is a list of the displays I have - Thanks, DavidNHD-2.4-240320SF-CTXI#-T 2610 8631N00704TNHD-2.4-240320SF-CTXI# 2610 8631Q100719WNHD-2.4-240320SF-CTXI# 2610 8631Q100719...
-
Will do when I get home this afternoonThanksDavid
-
And the display is a NHD-2.4-240320SF