dfansler
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 4
Activity overview
Latest activity by dfansler-
dfansler created a post,
Which model TFT (hopefully a 2.4") has double buffering?
I am working on a project where I update data on the LCD. While I am running an AT32UC at 66MHz (240MHz internally), the update of the screen is why too noticeable. I saw in a previous post that ...
-
dfansler created a post,
NHD-5.0-800480TF-ATXL#-T and NHD-5.0-800480TF-20 Controller Board No Touch?
I recently purchased 3 each of the above units. The X+,X-,Y+,Y- signals from the display are carried on the 40 pin conductor between the display and the NHD-5.0-800480TF-20 Controller Board. Ther...
-
dfansler commented,
Very small - only 2 changes, one to go from 18 bit to 16 bit and one to raise the refresh rate.The unit will only show true colors if I delay at least 4ms between sending each data word. This is re...
-
dfansler commented,
ok - thanksDavid
-
dfansler commented,
Now that I have the display running - and it will only run using the ILI9328 code, I have started to try to fine tune the timing to the display. The values I am having to use are MUCH larger than...
-
dfansler commented,
Hi Saurabh_B - thinking you were probably off for Good Friday, so I looked at the data on the different examples of code for the 2.4 display, and tried the 3 that seemed post probable.The ILI9340 w...
-
dfansler commented,
Saurabh_B: here is a list of the displays I have - Thanks, DavidNHD-2.4-240320SF-CTXI#-T 2610 8631N00704TNHD-2.4-240320SF-CTXI# 2610 8631Q100719WNHD-2.4-240320SF-CTXI# 2610 8631Q100719...
-
dfansler commented,
Will do when I get home this afternoonThanksDavid
-
dfansler commented,
And the display is a NHD-2.4-240320SF
-
dfansler created a post,
NHD-2.4-240320-CTCI#-T white screen only
Like others I have read about on the forum, I get nothing but a white screen. I have tried several different init codes I have found with no luck. I know the signals are getting to the display - ...