nathanbabu

  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 3

Activity overview

Latest activity by nathanbabu

  • nathanbabu commented,

    1. Community
    2. OLEDs
    3. OLED Update timing problem

    Kindly provide some solution for the below same Quote from: nathanbabu on October 25, 2017, 09:59:18 PM No Data send to OLED. we checked across data and control lines of OLED using CRO.But it p...

  • nathanbabu commented,

    1. Community
    2. OLEDs
    3. OLED Update timing problem

    No Data send to OLED. we checked across data and control lines of OLED using CRO.But it prints junk values always again power ON / OFF required to solve this scenario.After power OFF and ON Immed...

  • nathanbabu commented,

    1. Community
    2. OLEDs
    3. OLED Update timing problem

    Yes i reinitializing it.but after power ON it is working.during reset only junk values presents.i may think that during power off and on OLED Supply voltage is disconnected and connected and during...

  • nathanbabu commented,

    1. Community
    2. OLEDs
    3. OLED Update timing problem

    hi sir,thanks for your reply.I am using NHD - 0420DZW - AB5 OLED and my controller is 32 bit micro controller.when power OFF and ON Sequence is performed it is working fine.when reset button is pre...

  • nathanbabu commented,

    1. Community
    2. OLEDs
    3. OLED Update timing problem

    Hi,by pressing reset button periodically in my controller it will print junk values how can i eliminate the problem.kindly provide the solution for the above said 3 problems.thanks in advance.regar...

  • nathanbabu commented,

    1. Community
    2. OLEDs
    3. OLED Update timing problem

    And also i have one doubt,when power OFF and ON the display work properly.for every reset it will print junk characters.IS THERE ANY COMMAND NEEDED TO GIVEN AFTER RESET OR HAVE TO CONNECT ANY CONNE...

  • nathanbabu created a post,

    OLED Update timing problem

    1. Community
    2. OLEDs

    Hi,I am working with LCD with updating data to LCD in 250 mS Interval is working fine.but updating data to OLED is not working it will print only junk characters.Kindly provide solution for the abo...

    • nathanbabu
    • 2 followers
    • 10 comments
    • 0 votes

  • nathanbabu commented,

    1. Community
    2. OLEDs
    3. Not able to interface display with AT32UC3C0128C (32bit Microcontroller)

    Dear Sir,Parallel Mode 4 Bit Interface we are using. It is working fine in Arduino but not able interface with 32 bit microcontroller.

  • nathanbabu created a post,

    Not able to interface display with AT32UC3C0128C (32bit Microcontroller)

    1. Community
    2. OLEDs

    Dear Sir,I trying to interface with NHD - 0420DZW - AB5 with my micro controller but not able to get good results.kindly provide some sample program for testing.thanks in advance .Nathan Babu

    • nathanbabu
    • 2 followers
    • 2 comments
    • 0 votes

  • nathanbabu commented,

    1. Community
    2. OLEDs
    3. NHD-0420DZW-AB5

    Hi Sir, Thanks for your reply.Did you have any reference code for arduino?Regards,Padmanathan.P