MidknighTrain
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 1
Activity overview
Latest activity by MidknighTrain-
MidknighTrain commented,
ISSUE RESOLVED. PLEASE IGNORE THIS MESSAGE.Hello Saurabh_B,Sorry for reopening this issue, but I just have one question. Is it possible to turn off the back light using this controller? I tried con...
-
MidknighTrain commented,
Hi Saurabh_B,I found out the mistake that I made, and I'm terribly sorry for wasting your time. I misread the direction of the pin on the FPC adapter breakout board, so I was connecting pin 33 (thi...
-
MidknighTrain commented,
Hi Saurabh_B,If I'm using the multimeter correctly (sorry I've never used one before), the launchpad I'm using is providing ~600mA @ 3.3V.Thanks
-
MidknighTrain commented,
Hi Saurabh_B,No I did not. I only provided it with 3.3V. I wasn't sure if I should connect VDD to 19.2V since the datasheet says it can only handle ~3.3V. But if that's how the controller is setup ...
-
MidknighTrain commented,
Hi Saurabh_B,I've just tried to power on the LCD and the backlight, but nothing happened, not even the flickering that you were talking about. I connected VDD to 3.3V, GND to GND, B/L Enable signal...
-
MidknighTrain commented,
Hi Saurabh_B,I'm not quite following. Does this means that the B/L Enable pin should be connected to a GPIO pin on my microcontroller to be toggled HIGH or LOW to control the backlight? The datashe...
-
MidknighTrain created a post,
NHD‐5.0‐800480TF‐34 Controller Board Back Light (B/L Enable)
The datasheet for this controller board can be found here: https://newhavendisplay.com/controller-board-for-5-tft-displays-34-pin-ffc-16-bit-parallel/I'm having trouble getting the back light to tu...