• Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 1

Activity overview

Latest activity by balazs
  • balazs commented,

    Hi Paul,Since we have talked about the possible solutions, I tried them all of them. I have failed to resolve the issue, so I am using the display with this symptom.I mean I am drawing the characte...

  • balazs commented,

    Hi Paul,Well, I am from Hungary so if it is available to speak throuh Skype then I would prefer to do so. If it is okay for you, than may you send me your Skype-name in a personal message?

  • balazs commented,

    Hi Paul,I am still stuck with this problem. Do you have any ideas I should try? What about the orientation of the display is that right?Regards, Balázs

  • balazs commented,

    The display is mounted with its connector on the upper side. So like in the position in the datasheet. ( Is this correct? I hope so...   I tried the configuration data 0b1...

  • balazs commented,

    Hi Paul!Thank you very much for your response.Well, I have modified the data sent after the command 0xA0. The only modification that resulted normal picture in the screen was the A[1] bit. When I s...

  • balazs created a post,

    Issue about drawing on NHD-1.27-12896UGC3

    Dear All,I am using type NHD-1.27-12896UGC3 in my current project but unfortunately experiencing issues with addressing the pixels. I seems like the display origin is not in the top left corner, bu...