Paul_B
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 165
Comments
Recent activity by Paul_B-
Brilliant, thank you for sharing Mark!
-
Brilliant, thank you for sharing Lassi! Are you pulling the data via the SDS port?
-
Hello,PCLK is used to control panel refresh rate.VSYNC is used to reset the LCD row pointer to top of the display.HSYNC is used to reset the LCD column pointer to the edge of the display.Regarding ...
-
Hello,Yes you can, however the values attached are verified to work.Good luck!
-
Hello,I’m sorry, unfortunately I am not familiar with the FT800 gfx engine. However, I am more then happy to help out with your timing issues!To figure out the required timing parameters open up th...
-
Hello,TPS61165 from TI is an acceptable choice. You can also use FAN5333BSX:http://www.digikey.com/product-detail/en/FAN5333BSX/FAN5333BSXCT-ND/3042778Both will get the job done :)
-
Hello,Question 1: What is the correct pin out?Answer: The pin description can be seen on page 4 in the displays datasheet. https://newhavendisplay.com/content/specs/NHD-4.3-480272EF-ATXL.pdfPin 1: ...
-
Hello,Your timing characteristics look correct, one thing I did notice from the elinux wiki is that your panel-info {},needs to change from bpp <16> to bpp <24>.Please keep me posted on your progre...
-
Hello,To answer your question yes, it is definitely possible. If you have some shorter jumper wires on hand it wouldn't hurt to swap them out.However, I do not believe this is the culprit
-
Hello,Regarding your first post, can you please tell me if your MCU has built-in pull up resistors?If so it is possible that it could be causing a weak pull-up.Finally, I recommend you use 10k Ohm ...