Paul_B
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 165
Comments
Recent activity by Paul_B-
Hey Carl!The select example projects on our GitHub page are Arduino Sketches. You don't need to import it as a traditional Arduino Library. Regarding the EVE Screen Editor, I don't believe there is...
-
Hello,Page four in the displays datasheet does not list power and GND tied together. The upside-down triangle represents ground and the right-side up triangle represents power.NHD-320240WX-COTFH-V#...
-
Hello,Thank you for reaching out. NHD-320240WX-COTFH-V#I041 is a 3.3V module not 5V. We will work with Jameco to have the part description corrected on their website.In the mean time please review ...
-
Hello Rob,Thanks for reaching out. NHD-C12864A1Z-FS(RGB)-FBW-HT1 contrast can be controlled via software using the Electronic Volume Commands and V5 Voltage Regulator Internal Resistor Ratio Set. P...
-
Hello,NHD-C12864A1Z-FS(RGB)-FBW-HT1 is a COG display, however the glass is attached to a pcb which contains current limiting resistors, please see page 3 in the displays datasheet.https://newhavend...
-
Hello,Thanks for reaching out. There are multiple ways to control the displays heater.1. The simplest method is to apply +12V to pin 14 and Gnd to pin 1.2. Second you can use an external circuit to...
-
Morning Facotl,Correct pin 1 starts from the left hand side, glad to hear your display is up and running :)
-
Morning,It is typically preferred to supply the displays Typ. Voltage when ever possible, however in your case supplying 3.3V is perfectly acceptable :)
-
Morning Cacio,I’m sorry to hear about the trouble you are having with NHD-C12864LZ-FSW-FBW-3V3. All displays are tested before they leave our facility, chances that it is DOA is fairly low.I looked...
-
Hello,Thanks for reaching out, NHD-C12832A1Z-FSW-FBW-3V3 is meant to be soldered directly to a pcb. We sell a 17 pin Thru-hole to 2x4 Conversion board for NHD-C12832A1Z displays. All necessary capa...