Engineering Support
Community moderator- Following 0 users
- Followed by 1 user
- Votes 10
- Subscriptions 784
Comments
Recent activity by Engineering Support-
Official comment Hi Clovis, We have addressed this through your Support Center Request. Please refer to that response for further details.
-
Hi Sieun, That's great to hear! If you have any more questions or concerns regarding our displays, feel free to reach out again.
-
Hi Sieun, Thank you for providing the photo. I checked the lot code and I couldn't find any documented issues. This is most likely an initialization problem. Did the changes I suggested have any ef...
-
Hi Sieun, I can answer your questions below: 1. Given the measurements above, what additional condition does the FL7703NI require to accept LPDT commands? Is there any known sensitivity in escape-e...
-
Please see below for the initialization sequence for using 2-Lane mode GP_COMMAD_PA(4);W_D(0xB9); /// Set EXTC W_D(0xF1); //1 W_D(0x12); //2 W_D(0x87); //3 GP_COMMAD_PA(4);W_D(0xB2); ///S...
-
Official comment Hello, Thank you for reaching out. Could you please tell me if you are using 2-Lane or 4-Lane mode? Best Regards, Engineering Support
-
Hello Lilian, As the NHD-2.4-240320CF-BSXV-F display does not support MIPI interface and only supports 3/4-wire SPI interfaces. I will recommend you to look at our example code NHD-2.4-240320CF-BS...
-
Hi Adam, Unfortunately, with the current design, it is not possible to control the backlight on the NHD-2.8-CSXP-BREAKOUT display module.
-
Hi, Thank you for your inquiry. Please note that our NHD-2.4-240320CF-BSXV-F display supports only 3/4-wire SPI interfaces. Could you please clarify what you are trying to achieve and which develop...
-
Official comment Hello Valentin, Yes, it is possible to use 4-wire SPI for the NHD-2.8-240320AF-CSXP-FCTP. This can be seen in page 5 of our datasheet for this display, which I will provide below Please let me know...