Touch shifting on NHD-7.0-HDMI-N-RSXV-RTU

sherlock

Hi,

I have sent an e-mail to nhtech@newhavendisplay.com, but did get any response.
So I ask my question here. Hope anyone can solve my problem.

I'm using NHD-7.0-HDMI-N-RSXV-RTU on my Win 10 PC. And connected with HDMI and USB.
But my touch panel has shift at the edge.

For an example:
  assume that left-top is origin (0,0) , total 800x480 pixels.
  when I touch (20, 20), the edge of panel, it responses at (50, 30) (obvious shift)
  but when I touch (400, 240), the center of panel, it responses at correct position (400,240)

Is that working properly? Why? Should I replace a new panel?


Very thanks

0

Comments

1 comment

Date Votes
  • Sergio_M

    Hi,

    It may seem the touch panel might have not been calibrated correctly, which could explain the touch shift. The AR1100 (Resistive Touch Screen Controller IC) shows up like a USB mouse, it works on all operating systems as the computer doesn't know it's a touch screen, it just thinks its a mouse. You can adjust the AR100 to consider itself a Touch Digitizer, supported by many but not all computers.

    If you have a Raspberry Pi available you may  re-calibrate the touch IC via USB using the following program:

    https://github.com/tom-2015/rpi-AR1100

    or

    If you have a Windows computer you may re-calibrate the touch IC via USB using the following program:

    http://www.microchip.com/wwwproducts/en/AR1100#documentation


    Hope this helps,

    0

Please sign in to leave a comment.

Didn't find what you were looking for?

New post