Saurabh_B
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 241
Comments
Recent activity by Saurabh_B-
Would it be possible to get a pin-out diagram, along with your initialization routine?
-
It is not possible to test the display without using a microcontroller.You would need to initialize the display then change all off the pixels to black using the controller.
-
Hello Charlie,Sorry for the delay, The heater should be activated whenever the display starts to show any signs of lag from the cold weather.This will typically start to occur ~-10°C. However many ...
-
The capacitive touch panel displays also provide a better resolution.Could you also provide a video of where the displays cut off?
-
No, Unfortunately this display does not allow you to flip individual characters.
-
Can you tell me when you purchased the NHDev Development board?It seems that you have an older version of the software. the NHD-1.2-128160TF was an older model we used to sell and has been replaced...
-
Hello Bill,Unfortunately because these are Passive Matrix OLEDs the brightness of the pixels can vary based on how many pixels are on in a row.The brightness will be higher if you only have a few p...
-
The first thing you would have to do is to add a short delay when the power is applied.Then before you start writing I would recommend sending the return home command.There is also a clear display ...
-
Hello,The VLCD is generated by the booster circuit on the display and is controlled via software (Set Electronic Volume Command). This voltage doesn't need to be applied, and you should see 9~11 V ...
-
Can you tell me if you are getting an ACK from the display?