nathanbabu

  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 3

Comments

Recent activity by nathanbabu Recent activity Votes
  • Kindly provide some solution for the below same Quote from: nathanbabu on October 25, 2017, 09:59:18 PM No Data send to OLED. we checked across data and control lines of OLED using CRO.But it p...

  • No Data send to OLED. we checked across data and control lines of OLED using CRO.But it prints junk values always again power ON / OFF required to solve this scenario.After power OFF and ON Immed...

  • Yes i reinitializing it.but after power ON it is working.during reset only junk values presents.i may think that during power off and on OLED Supply voltage is disconnected and connected and during...

  • hi sir,thanks for your reply.I am using NHD - 0420DZW - AB5 OLED and my controller is 32 bit micro controller.when power OFF and ON Sequence is performed it is working fine.when reset button is pre...

  • Hi,by pressing reset button periodically in my controller it will print junk values how can i eliminate the problem.kindly provide the solution for the above said 3 problems.thanks in advance.regar...

  • And also i have one doubt,when power OFF and ON the display work properly.for every reset it will print junk characters.IS THERE ANY COMMAND NEEDED TO GIVEN AFTER RESET OR HAVE TO CONNECT ANY CONNE...

  • Dear Sir,Parallel Mode 4 Bit Interface we are using. It is working fine in Arduino but not able interface with 32 bit microcontroller.

  • Hi Sir, Thanks for your reply.Did you have any reference code for arduino?Regards,Padmanathan.P

  • Thanks for your reply..Kindly provide sample code for SPI Interface. And i am modified Jumper settings as per the Specification sheet in your website.And  I am using arduino for this interface prog...