Sergio_M
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 35
Comments
Recent activity by Sergio_M-
Hello, Your statement is correct that the DUE IO pins are at a 3.3V logic level where the FT81x-SHIELD is working with 5V logic levels due to the voltage level shift provided by U1.Changing the shi...
-
Hello,The recommended FFC connector is Molex 54104-4031 or equivalent.Hope this is helpful.
-
Hello,I'm sorry to hear you are having issues with the module.Can you please confirm you are using a known compatible Arduino (UNO, NerO, Leonardo, Mega 2560) and at least a 5V DC power supply with...
-
Hello,You may use the resistive touch panel by either using an external 4-wire resistive touch controller IC such as ones offered by Microchip, TI, etc., or by using your MCU's ADC pins and manuall...
-
Hello Jon,Thank you for your interest in Newhaven Display!Please view the attached EDID Timing table, it should have what you are looking for in regard to the start and end positions for the Sync ...
-
Hello,Unfortunately, the Due is not compatible, the NHD-FT81x-SHIELD requires an operating voltage of 5V to be supplied by the Arduino.The Due's IO pins are not tolerant of the 5V levels from the s...
-
Hi Martin,Please have a look at page 28 of the datasheet.User defined characters can be loaded via 512 bits (8 characters) Character Generator RAM (CGRAM).Spec: https://newhavendisplay.com/content/...
-
Hello eoldynski, Although the display's controller (ST7032) is capable of running I2C, the serial data pin is an input only and does not have the I2C pins brought out from the controller, unfortuna...
-
Hello, The following techniques can be used to improve ESD shielding for our displays.One or more options may be suitable depending on your application.- Add a TVS diode between VDD and GND- Tie th...
-
Hi RAGHUL,Using a 10 ohm resistor in series with the LED backlight and a 3.3V source voltage will provide the 30mA at 3.0V to the LEDs.Formula: R = (Vs - Vf) / IfHope this helps!